Grandstream UCM6100 series Initial Setup Guide Instrukcja Użytkownika Strona 1

Grandstream Networks, Inc. www.grandstream.com Grandstream Networks, Inc. UCM6100 Basic Configuration Guide

10 PROVISIONING & ZERO CONFIG Grandstream SIP Devices can be configured via Web interface as well as via configuration file through TFTP/HTTP/

11 EXTENSION ASSIGNMENT In the Auto Provision settings, users have the option to enable “Automatically Assign Extension”. If enabled, an extension

12 CONFERENCE BRIDGE The UCM6100 supports conference bridge allowing multiple bridges used at the same time: • UCM6102/6104 supports up to 3 con

13 4. Click “Save” at the bottom then “Apply Changes” at the top. We should now have a conference room created and the status page will display th

14 IVR CONFIGURE IVR IVR configurations can be accessed under the UCM6100 Web GUI->PBX->Call Features->IVR. Users could create, edit, view

15 Figure 19: IVR – Create New IVR 6. The next section on configuring an IVR would be the Key Pressing Events. Users can direct calls based on

16 TRUNKS ANALOG TRUNKS Go to Web GUI->PBX->Basic/Call Routes->Analog Trunks to add and edit analog trunks. • Click on "Create New

17 Note: If there are reports of calls being dropped and lines are not disconnecting properly, this could mean that there are line settings mismatch

18 Figure 22: VoIP Trunks – Create New Register SIP Trunk After creating the SIP trunk, users can click the on the right of the VoIP trunk for m

19 CALL ROUTES OUTBOUND ROUTES In the UCM6100, an outgoing calling rule pairs an extension pattern with a trunk used to dial the pattern. This allow

2 TABLE OF CONTENTS OVERIEW ... 4 SETUP GUIDE SC

20 Figure 25: Routes – Create Outbound Route INBOUND ROUTES In the UCM6100, an incoming calling rule allows for various inbound destinations. Us

21 SETUP INBOUND ROUTE 1. Click on “Create New Inbound Rule” 2. For “Trunks” select the SIP trunk that has been configured. (e.g. GS Trunk) 3.

3 TABLE OF FIGURES Figure 1: Typical UCM Scenario ...

4 OVERIEW This document will provide instructions on how setup a UCM6100 series from an out of the box state to a fully functional state. This inc

5 QUICK INSTALLATION CONNECTING THE UCM6102 Figure 2: Quick Installation Guide for UCM6102 ACCESS UCM6100 SERIES WEB INTERFACE Accessing the UCM

6 CREATE USER EXTENSION CONFIGURE EXTENSION RANGE First part of configuring the UCM6100 series should be about planning for expansion. Here are so

7 BATCH & SINGLE USER CREATION So now that there’s extension ranges configured, we can now begin creating users to prepare for the provisioning

8 Figure 7: Create User Extension – Created Single User STEPS ON ADDING BATCH OF USERS 1. Navigate to PBX Basic/Call Routes  Extensions 2. C

9 At this point the Extensions page should look similar to this: Figure 10: Create User Extension – Single and Batch Add Extensions Created For